Wiring harness to the injectors / injection valves made of silicone cables (durable up to 150°C) for VW Golf, Corrado and Passat G60.
The version of the injector cable harness offered here is especially suitable for motor sport applications. Cables with a temperature resistance of 150° C are used to achieve a long-term durable solution even under extreme conditions.
The cable harness to the injection valves is exposed to extremely high thermal loads. Due to the high heat, the cables quickly become brittle - often directly at the connector. As a result, the injectors can no longer be controlled properly, which can lead to damage to the engine. The use of this wiring harness is also recommended for vehicles with a lot of heat, such as the Golf 1 with G60 conversion.
Our wiring harness is made of heat resistant silicone cables (heat resistant up to 150°C) to counteract this problem. Therefore our wiring harness has a much longer life span. The wire harness can be mounted in the original plastic housing.
precisely fitting injectors with higher flow rate for G60; recommended for 250 HP and above
- for extreme conversions with VR6 or 16V Turbo
- suitable for E85 operation
315ccm (at 3bar) injectors for VW Golf G60 with large HVAC
for 16VG60 and 16V Turbo - engines recommended up to 350 PS
Oil feed line and attachment material for G40 and G60 loaders
with cable and plug
4 sputter bearing cups for top, 4 normal ones for bottom
for fixing heat protection tape
63.5 mm - stainless steel, year 79-83, EC type approval
4 high-strength H-shaft conrods from K1 for 16V ABF engine - ideally suited for turbo conversion
incl. ARP screws