Special tool for pressing off the charge air system.
The charge air system can easily be checked for leaks. One tool part is mounted before the throttle valve, the other directly after the charger/compressor. This allows the system as a whole to be pressurised and a leak to be located on the HVAC or on hose/pipe connections. The pressure plugs have 3 different diameters of 50, 60 and 70mm each and can therefore be used in all common charge air ducts. As the charge air hoses are flexible, intermediate sizes are no problem.
During the work, make sure that the pressure on the compressor is turned down. A working pressure which corresponds to the normal boost pressure + 0.5 bar is completely sufficient!
The tool kit is suitable for all supercharged engines, whether with G40, G60 or G65 G-supercharger, turbo or supercharger.
Scope of delivery:
- sealing plug with display of 0 - 4 bar
- sealing plug with valve
Timing belt for the G-Lader in 11,5mm for G40 and G60
Set of sealing rings for G40 and G60 G-Lader
Oil feed line and attachment material for G40 and G60 loaders
Sintimid sealing strips and timing belts for G40 and G60 loaders
Sealing plate for cast sheet
for large LLK